The
X-Valve is the second generation ReTro Valve. Lightweight
aluminum construction, hyperfast recharging integrated regulator,
Reactive
Trigger technology, and the Lvl 10 are all standard equipment,
making this our most popular upgrade!
The
X-Valve's regulator fully recharges in less than .04 seconds,
which means this:
Shootdown is a thing of the past. The hyperfast recharge
rate allows the X-Valve to fire at 26+ times per second
without shootdown, faster than anyone can pull the trigger.
The regulator
also maintains consistent pressures inside the valve. This
in turn gives you consistent velocities which allows tighter
shot groupings.
The
Reactive Trigger actually pushes your finger
back after firing each shot, enabling you to easily reach
much higher rates of fire as compared to the standard
'Mag valve.
The X-Valve comes with everything you see here and is
a direct replacement for the standard 'Mag valve. Slide it
right in
and go to town!
Comes
standard with LvL10 upgrade! http://www.automags.org/resource/level10/index.shtml
The
$225 price is part of our GO X-VALVE! program and requires
you to trade in your original complete valve. We will
email you after receiving your order with instructions
on where
to send your valve. Do not send your valve
to us until you receive full instructions from us! Once
we have your valve we will send out your new X-Valve.
If you wish to
buy the X-Valve without turning in your old valve,
the price is $325. We cannot give additional discounts
if
you trade
in your existing stainless Retro Valve or for Lvl 10
equipped valves - we can only credit you $100.
SAVE
TIME ON GO X-VALVE! Give us the serial
number of the valve you will be turning in on the "Message" line
when you are placing your order.
IMPORTANT
NOTES:
1. Warning: The
X-Valve will not fit into an Automag RT. (It
WILL fit a RT Pro.) If you have a RT, please
do NOT
order an
X-Valve.
2. The
X-valve will only run on compressed air or Nitrogen -
not CO2.
3.
If you are going to use the X-Valve in a RT Pro or Emag,
KEEP YOUR ON/OFF ASSEMBLY.
The assembly
provided with the valve kit will have the
wrong size on/off pin
for
your
marker.
4.
Some fine tuning of the Lvl 10 may be required.
5.
When you first install
the X-Valve,
you will need
to turn up the velocity.
