|
|
|
PC BOARD INFORMATION
|
- There are no user adjustable components
located on the E–Mag Xtreme PC Board.
- Keep all liquids away from the components
on the board at all times.
- Make sure that no wires are pinched when
assembling and disassembling the marker. This can cause the
insulating plastic cover on the wire to break, exposing the inner
conductive wire to the frame of the marker. This in turn can cause a
short or general failure of the marker.
- The frame carries the negative DC from the
battery to the PC Board. Make sure that the screw that holds the PC
Board in place is reasonably tight to ensure a good electrical
connection.
- When removing wiring connector from the
sockets make sure that no excessive force is applied to any one wire
as this can cause a break. Grasp the wires as close to the connector
as possible and gently pull straight up and out.
- When reinstalling the connectors into the
sockets, note that they are keyed, and can only be reinstalled one
way.
|
|
