|
|
|
|
|
QUICK OVERVIEW OF HOW TO USE THE
X-MAG
|
- Ensure that the battery has been charged
overnight before first use.
- Introducing 600 to 1000 psi of air pressure
to the paintball marker will charge and cock the marker.
- The X-mag uses a standard threaded Cocker
barrel.
- The velocity adjustment nut is on the back
of the valve body and requires only one complete turn to adjust from
200 to 300 fps.
- Field stripping to remove the valve and
bolt is accomplished by unscrewing the knurled field strip screw
located underneath the frame while the air supply is off.
- THE SAFETY MUST
BE “OFF” TO PULL THE TRIGGER BACK AND THE TRIGGER MUST
BE PULLED (WITH SELECTOR SWITCH POINTING FORWARD, 9 O'CLOCK TO
“M”) TO SLIDE THE VALVE BODY OUT.
- The X-mag body has a locking pin for
alignment in the regulator body that allows the valve body to only
come out part way before you must twist the valve body clockwise to
continue sliding out the back. Once removed, the entire valve and
bolt assembly is available for cleaning.
- When adjusting the velocity regulator, dry
fire the paintball marker several times before chronographing to
allow the regulator piston and spring to seat properly. Always start
below your intended velocity and work your way up.
|
|
