Home

Safety
Handling Precautions
Welcome
Quick Start
General Description
Technical Specifications
Operating Modes
Programming
Maintenance
Cleaning
Lubrication
Marker
O–Rings
Valve
Level 10 Bolt
Grip Frame
Battery
PC Board
ACE Board
Electronic Wiring
Parts Identification
Troubleshooting
Recommended Options
Warranty
Service & Shipping
Contact Information

Lots of Xtras!!!

VALVE AND BOLT ASSEMBLY

ID#	Part Description	ID#	Part Description
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17	Regulator Nut Regulator Nut O–ring Regulator Spring Inner Regulator Spring Outer Regulator Piston Regulator piston O–ring Regulator Body O–ring Regulator Body Valve pin O–ring Regulator Seat Regulator Seat O–ring Valve Pin Field strip screw washer Field strip screw Outer Quad O–ring Quad O–ring On/off pin .712	18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33	On/Off Top On/Off Small O–ring On/Off Bottom O–ring On/Off Bottom Valve Body Bumper Backing Washer Power Tube O–ring Carrier Carrier O–ring Shim Power Tube Tip Power Tube O–ring Bolt Foamie Bolt Spring

VELOCITY ADJUSTMENT

The velocity of your X-mag is adjusted by increasing or decreasing the regulated pressure. This is accomplished by turning the regulator adjusting nut located on the back of the regulator body. Only a minimal amount of rotation is necessary to adjust the velocity. We recommend that you always start at a low velocity setting and continue to screw the adjustment clockwise up to your desired setting.

Always fire several shots to seat the regulator piston and spring. High velocities will cause the blow-off valve built into your system to vent air out the back of the regulator body. If you hear air venting from the back of the regulator body, stop and re-chronograph the paintball marker immediately. We found the best performance to be in the 270-280 fps range. Occasionally grease the threads of the velocity-adjusting nut.