|
Wires are used to
connect the battery, ACE board, PC board, and optional warp feed unit.
When working on the X-mag make sure
that you do not apply any excess force to the wiring by pulling on them.
Also make sure that the wires do not get caught between the main body and
grip frame when reassembling the unit.
As with any other electrical device,
ensure that you do not get any water or other liquids on any of the
boards, battery or wires.
If for any reason your marker should
get wet internally, immediately remove the battery. Make sure that all
components are thoroughly dry before attempting to reinstall the battery.
If you are unsure about the correct method of drying your marker contact
your local certified Airgun Design representative or give our technical support department a call.
|
